奥特多蓄电池OT38-12充放电标准：

1. 奥特多蓄电池OT38-12 12V38Ah/10HR容量按国家规定的方法放电试验，10h率容量应在第一次循环不低于0.95C10，第五次循环应达到C10，放电终止电压应为1.8V。日自放电率小于额定容量的0.1％或月自放电率小于额定容量的4％；

2. 奥特多蓄电池应密封良好，无论立放或卧放均无电解液溢出；

3. OUTDO蓄电池应具有优良的防酸及排气性能，当压力超过正常值时应可靠排气，压力恢复正常值时应可靠密封，无论在任何情况下应确保排出的气体不含酸雾；

4. 奥特多蓄电池可以大电流放电，以30I10的电流放电1min，极柱不应熔断，其外观不得出现异常；

5. 奥特多电池密封反应效率不低于95%。

6. 奥特多蓄电池静置90d后，荷电保持能力标准公式计算不低于80%，完全充电的蓄电池表面应清洁。

1. Battery OT38-12 12V38Ah/10HR capacity discharge test according to the national regulations, 10h rate capacity should not be less than 0.95C10 in the first cycle, the fifth cycle should reach C10, discharge termination voltage should be 1.8V. The daily discharge rate is less than 0.1% of the rated capacity or the monthly discharge rate is less than 4% of the rated capacity;

2. The battery should be well sealed, no electrolyte overflow whether placed vertically or horizontally;

Outdo battery should have excellent performance of acid prevention and exhaust, when the pressure exceeds the normal value should be reliable exhaust, pressure to restore the normal value should be reliable seal, in any case should ensure that the discharged gas does not contain acid fog;

4. The battery can discharge at high current, discharging at current of 30I10 for 1min, the pole pole should not fuse, and its appearance should not appear abnormal;

5. The sealing reaction efficiency of Ottor battery shall not be less than 95%.

6. After the battery stands for 90 days, the standard formula of charge retention capacity is not less than 80%, and the surface of the fully charged battery should be clean.